Logo

What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?

12.06.2025 04:52

What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?

He then asserts :

But it can get overloaded, and no longer works.

Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.

Veteran investor makes surprising Fed rate call after jobs report - TheStreet

This device then solves the entire problem.

2024–10–14 [Omar Gharbi Omar Gharbi ]

(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).

What is the recommended approach for creating a film or TV script? Should the script be written first or should the story be developed first? Why?

This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.

2024–10–00 [ Ammar Mahdi ] Ammar Mahdi

There are three different concepts here that are getting confused.

Three Seconds of Strength Training a Day Is All It Takes to Build Muscle Without Spending Hours at the Gym: Here’s How to Do It - The Daily Galaxy

This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.

The third is lightning and “how it gets conducted into a home.”

Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.

Are there any Indian wife swapping stories?

Because the load is inductive, the current lags the voltage.(by a bit).

OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.

But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).

iFixit is retroactively giving the Nintendo Switch a 4/10 on repairability - The Verge

One

“ A fuse is a device which protects the (circuit) against overload and short circuit.”

If the nominal power is 4,000 watts then the current at 230volts is 16 amps.

NAACP calls on Memphis officials to halt operations at xAI’s ‘dirty data center’ - TechCrunch

the problem then depends on "how fast does the fuse operate?".

At least they know the answer if they wanted it.

“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”

What is the dirtiest city in India?

It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.

Edit 2024–10.

A circuit breaker is similar, but is resettable.

Final AIDS/LifeCycle Travels Through Santa Barbara County - Noozhawk

An AC voltage/ current source, and an ac inductive load.

The bolt then partially travels down the line to your home.

What is lightning?

Everyone says the pet population is out of control. Everyone says you MUST spay or neuter your pets. No one wants to talk about how its almost $1,000 to spay or neuter a pet. Why is it so expensive if its so necessary? Animal shelters do it for free.

These devices are installed between the “hot” and “neutral” and protective ground.

(Dc diagram shown, AC is similar).

There are two important concepts here.

Top Stories: What to Expect at Apple's WWDC 2025 'Sleek Peek,' macOS Tahoe Rumors, and More - MacRumors

[old diagram got deleted by accident]

nine

2024–10–11 [Bobby Sanchez Bobby Sanchez ].

Did sharing a wife turn out okay?

So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.

P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.

but this device (an Inductor) … impedes the rapid changes in the current.

So, the voltage could go up to 500 volts, and the fuse will not open up.

Barnstars:

eight

a photo is worth a thousand words.

The other is “what does a “fuse” do?”

The MOV will conduct when the voltage exceeds 50% of line voltage.

Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.

so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.

One is “what exactly is in a ‘surge protector’ ? ”

When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.

This is where this question deviates from being a 'generic' question, and becomes more specific.

what exactly is a ‘surge’ protector?

Upvotes:

This is the picture of an electronic coil of wire wound around a core of magnetic material.

Can the fuse protect the electronic devices from lightning instead of a surge protector.

It seems Mohan does not understand the difference between a comment and an Answer.

He then describes the function of a fuse.

so, what happens?

These are simplified answers to the original question, and does not change anything I wrote above.

There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.

This is where the MOV conducts again, and dissipated the energy.

“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”

but I think this circuit , shows a few more pieces.

2024–10–10[John johnson John Johnson ]

This is 'the assistant's answer'

This one hit behind the barn.

He then describes Rainy Season and Lightning.

What does a fuse do?

Here is a simplified AC power diagram.

I post the exact comment here.

Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".

So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.

This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.

Now when you have a certain ac resistance, then a current flows in a loop.

At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.

2024–10–16 [ OO OLAOYE OYEBODE ]

For this case there are devices called Metal oxide varistors (MOV).

First Sentence:

But… the neutral is now “floating” because of the 1 ohm resistance.

[image of Common-mode choke]

2024–10–11 [Victor Olarewsju Victor Olarewaju ]

A fuse is a non-resetable over current circuit protector.

At one ohm, the resistor has a maximum of 1 watt power.

Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.

In schematic diagrams this is the symbol for a fuse:

2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?

It also is a device that limits the change in current flow.

Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.

And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.